Roof pitch calculator
Works out your roof pitch from a level and a tape, a rise and run, or an angle, and shows it as degrees, percent and a multiplier too.
Your roof pitch is 6 in 12.
- Degrees26.6°
- Percent50%
- Multiplier1.118
Stay off steep roofs. Measure from a ladder at the eave, or in the attic along a rafter. Don't walk a steep roof to measure it.
Show the working
- Drop. The roof is 6 in below the level at the 12 in mark. The level covers 12 in, so the drop is the pitch: 6 in 12.
- Round to the nearest 1/4 in 12: 6 in 12.
- Degrees: atan(6 ÷ 12) = 26.6°.
- Percent: 6 ÷ 12 × 100 = 50%.
- Multiplier: √(12² + 6²) ÷ 12 = 1.118.
The degrees, percent and multiplier are worked out from the rounded pitch, so they match the number you carry to the other calculators. How we calculate
Three ways to measure a pitch
Pitch is how many inches the roof rises for every 12 inches it runs. You can find it three ways, and each gives the same answer.
- A level and a tape. Hold a level flat against the roof and measure down to the roof at the 12 in mark. The drop is the pitch.
- Rise and run. Measure how high the roof climbs and how far it covers level, then divide. In the attic, the rise is the height from the top of the wall to the ridge, and the run is half the width.
- An angle. Lay a phone angle app or an angle finder along a rafter or on the roof surface and read the degrees.
Pitch, slope and angle: the same thing three ways
A roof that rises 6 in over 12 in is a pitch of 6 in 12. It is also an angle of 26.6 degrees, and a slope of 50 percent, because it rises half as far as it runs. People use whichever suits their trade: carpenters say "6 in 12", plans often show degrees, and some roof makers quote percent.
The multiplier is the length of roof surface for every foot of level run. At 6 in 12 it is 1.118, so a rafter needs 1.118 ft of length for each foot of run.
Common questions
What does "6 in 12" mean?
For every 12 inches the roof covers going across, it climbs 6 inches. Say it as "six in twelve" or "a six pitch".
Why is my answer rounded to the nearest 1/4?
A level and a tape can't tell 6 in 12 from 6 1/16 in 12, so a quarter inch is as fine as the measuring goes. The working shows the unrounded figure.
What if the two sides of my roof differ?
Measure each side on its own. A roof with two different pitches needs a separate answer for each side.
Can I measure the pitch from the ground?
Only roughly. Stand square on to the gable end and take a straight-on photo, then read the roofline's angle with a phone angle tool. Lens distortion and a tilted phone will move the number, so check it against a measurement taken at the roof.
Related
Last reviewed 18 November 2026 · How we calculate · Report a wrong answer